Description

Edwards 867STRA-AQ Horn Strobe

860 Series xenon strobe beacons with horns – bright, low current, high decibel, combination signals. Designed for use where a distinctive visual or audible signal – required. The housing – made of gray, engineered thermoplastic. The strobe and horn can – operated independently.

The 867STR (indoor) and 868STR (outdoor) Series can – surface mounted on the supplied surface box. The 869STR and 869DSTR Series beacons can – flush mounted. Designed to mount in a standard  electrical box with extension. The 869DSTR Series – Diode Polarized for use in electrically supervised circuits.

Edwards 867STRA-AQ Horn Strobe

Be sure that the hook flange is facing outward.
The designation “TOP” on boxes denotes orientation of box after installation.
Attach the mounting plate using two #8-32 screws provided with the surface box. Or four #8-32 screws provided with weatherproof box. The flush box uses two #8-32 screws (not provided).
Bring the signaling circuit field wiring into the electrical box.
Connect signaling circuit field wires to terminals on horn/strobe assembly (Figure 2 through Figure 4).
Ground in accordance with national and local electrical codes.

Mount the horn/strobe on the mounting plate.
a. The inside of the top of the grille has hinges that pass through cutouts. And engage with tabs on the mounting plate. With the bottom of the grille lifted out slightly, place the grille over the mounting plate.
b. Properly seat the grille by pressing the bottom in.
c. Fasten the bottom of the grille to the mounting plate by installing the captive combination drive screw.
7. Apply power and activate the horn/strobe unit to verify that it is operating properly.